4.27. Min or Max Setting Ignored by RiskResultsGraph( )

Applies to: @RISK 5.0 and newer

I have a RiskResultsGraph( ) function set up as follows, because I want to set the left edge of the graph at –10:

=RiskResultsGraph(A1,B4:M30,0,,5,90,-10)

But after a simulation, the graph still shows same x axis as before.

With RiskResultsGraph( ), you must specify both Min and Max, or neither. Supply a Max value in addition to your Min value, and the graph will appear as you wish.

Last edited: 2015-09-18

This page was: Helpful | Not Helpful