Home6.3 Network GuideServer SetupStep 2: Set Options—Port Numbers (6.x)

1.3. Step 2: Set Options—Port Numbers (6.x)

Disponible en español: Cambio de Número de Puerto para Licencias de Red 6.x
Disponível em português: Modificando número da porta de rede

Applies to:
Palisade network software releases 6.x
If you have a 7.x network, see Step 2: Set Options—Port Numbers (7.x).

Click Start » All Programs » Palisade Network Server » Server Manager. Server Manager will update any 5.x license process; see What if I already have a Palisade 5.x license on this server?

The defaults are to select both communication ports dynamically, and to disallow borrowing. Your current options are shown in the Network Server Information box. Click Options if you want to change them. Otherwise, skip to Server Step 3.

Port Numbers

The FLEXnet licensing software uses two TCP/IP ports for communications between client and server. They are called the lmgrd port and the Palisade or vendor daemon port. You can allow both of them to be chosen dynamically (the typical setting), or you can specify either or both of them. "Dynamic" means that the software chooses the ports each time the license service starts.

By default, a first-time install of Server Manager allows both ports to be chosen dynamically. However, if you're installing Server Manager on a server that already has Palisade 5.x licensing software, Server Manager will bring forward any port selections you have already made.

If you want to specify port numbers, it's best to do that before you install multiple clients. If you change the lmgrd port number later, you will also need to change it on every Concurrent Network client that is already installed.

Caution: If you have other FLEXnet-licensed products on the same server, then either every one needs to specify a unique lmgrd port number, or none of them can specify an lmgrd port number.

To find which port numbers the license software is using:

If you have not specified port numbers, you can determine which ports the server is actually using. Click Status in Server Manager.

To set or change the lmgrd port:

  1. In Server Manager, click Options.
  2. On the Options screen, under Communication Port Number (lmgrd), specify a port number (not otherwise used) or select Dynamic.
  3. Click OK, then Stop Service, then Start Service.
  4. In a Concurrent Network, change the lmgrd port number on any clients that have already been installed. See Redirecting 6.x Concurrent Clients to a New Server or Port Number.

To set or change the Palisade vendor daemon port:

In Server Manager 6.2 or later, edit the vendor daemon port on the same Options screen, just below the lmgrd port. (In Server Manager 6.0 or 6.1, on the main screen click Open .LIC Folder. Open the file Server.lic in Notepad and and place the vendor daemon port number on the VENDOR line, in this form:
VENDOR palisade PORT=12345
Then click Refresh in Server Manager.)

There's no software setting on the client for the vendor daemon port. However, if you previously found that you needed to open that port in the firewall of any installed clients, you will need to update the client firewall settings.

Last edited: 2016-03-16

This page was: Helpful | Not Helpful